home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
QRZ! Ham Radio 13
/
QRZ Ham Radio Callsign Database - Volume 13.iso
/
modfiles
/
ft8500.txt
< prev
next >
Wrap
Text File
|
1999-04-07
|
2KB
|
53 lines
Subject: Re: FT-8500 Need Mods
From: Mike Obermeier <ifindem@mail.calypso.com>
The mod is easy. This will give you 137-174mhz and 410-470mhz Tx/Rx.
1. disconnect power and antenna (like, you would'nt of done it already.)
2. open up the case by removing the screws and gently removing the cover and
unpluging the speaker.
3. locate and CUT the GREEN WIRE on the CONTROL BOARD ( the vertical board
behind the control panel.
4. reassemble the radio.
5. RESET THE MICROPROCESSOR (so much for the memory!)
(press and hold [D/M] & [REV] & [ENT] & turn the power on)
(turn off the radio).
(press and hold [SCAN] & [HOME] & turn on the radio - extended RX mod).
Date: Thu, 14 Jan 1999 18:51:45 -0600
From: Tommie Taylor <tommiet@n-link.com>
To: editor@qrz.com, tommiet@n-link.com
Subject: MOD Addition to FT8500 Yeasu
Please add this mod to your radio mod with Mike's.
I have added a line or two in addition to mikes mod for the operators
that program there FT 8500 with Computer Software.
After doing Mikes Mod the radio will not program VIA ADMS-2 software
without doing the added
steps I have added.. SEE BELOW
__________________________________________________________________________
Mike Thanks for this mod but there was 1 step that I believe should be
added as this really
made me think this mod was not any good:
Subject: Re: FT-8500 Mod Addtions
From: Tommie Taylor <tommiet@n-link.com>
ADDED BELOW
* If reprogramming VIA ADMS-2 Software, you must <SEND> template from
radio to
computer before Ft8500 will accept the reprogramming <REC> via
computer..
If you do not send template from radio the FT8500 will not accept the
freq from the computer,
This made me believe the mod above didnt work..
Again Thanks Mike for the mod... Tommie Taylor TeXaS
_________________________________________________________________________________________